Mitsubishi Outlander: Cigarette lighter
The cigarette lighter can be used while the ignition switch is in either “ON” or “ACC”.
1- Push all the way in.
The lighter will automatically return to its original position with a “click” when ready. Pull it out for use.
After use, insert the lighter to its original position in the socket.
NOTE
Do not leave the cigarette lighter removed from its socket, because the socket might become clogged by foreign material and be short-circuited.
CAUTION
(1) Do not touch heating element or lighter housing, hold the knob only
as burns may occur.
(2) Do not allow children to operate or play with the cigarette
lighter as burns may occur.
(3) Something is wrong with the cigarette lighter
if it does not pop back out within approximately 30 seconds of being pushed in.
Leaving the cigarette lighter pushed in for an extended period could cause fire.
If it does not pop out by itself, pull it out and have the problem corrected at
an authorized MITSUBISHI dealer.
(4) Do not leave the cigarette lighter pushed
in or insert the cigarette lighter from another vehicle. Otherwise, the lighter
may overheat and cause fire.
(5) It is recommended that only the lighter be inserted
in its socket. Use of “plug-in” type accessories may damage the socket and result
in poor retention of the lighter.
(6) When the cigarette lighter socket is used
as a power source for an electric appliance, be sure that the electric appliance
operates at 12 V and has an electric capacity of 120 W or less. In addition, long
use of the electric appliance without running the engine may run down the battery.
READ NEXT:
Ashtray
Push the tray centre (A) to open.
To remove the ashtray, pull up the inner part (B) from the sliding tray.
CAUTION
(1) Do not put papers and other things that burn into your ashtrays. If
you
Accessory boxes
Various small articles can be kept in here.
1- Door pocket 2- Sunglasses pocket 3- Tray 4- Centre accessory box 5-
Seat back pocket 6- Armrest tray* 7- Centre console box* 8- Cup holder 9-
Glov
Centre accessory box
Push the lid centre (A) to open.
SEE MORE:
ACD control mode display
Example: “TARMAC” mode is selected.
The currently selected control mode is displayed on the multi-information display.
In addition, when the control mode is changed, the selected mode appears on the
interrupt display screen of the information screen in the multi-information display.
The c
Making a flat seat
By removing the head restraints and fully reclining the seatbacks of the seats,
one large flat seat is achieved.
WARNING:
● Never drive while there are occupants sitting on the flat seat. This can be
extremely dangerous.
CAUTION:
● To make a flat seat, stop the vehicle in a safe
