Mitsubishi Outlander manuals

Mitsubishi Outlander 2007-2013 Service Manual

Mitsubishi Outlander 2007-2013 Service Manual

Service and Repair Manual for secong generation Mitsubishi Outlander, model years 2007-2013. This manual provides explanations, etc. concerning procedures for the inspection, maintenance, repair and servicing of the subject model. Unless otherwise specified, each service procedure covers all models. Procedures covering specific models are identified by the model codes, or similar designation (engine type, transaxle type, etc.).

READ NEXT:

 General

 How To Use This Manual

MAINTENANCE, REPAIR AND SERVICING EXPLANATIONS This manual provides explanations, etc. concerning procedures for the inspection, maintenance, repair and servicing of the subject model. Unless otherwis

 How To Use Troubleshooting, Inspection Service Points

TROUBLESHOOTING CONTENTS DANGER The SRS-ECU adopts the rollover specification that the curtain airbag and seat belt pre-tensioner operate at the occurrence of rollover. Therefore, do not tilt the vehi

SEE MORE:

 DTC P0703, P0705, P0711, P0712, P0713, P0715, P0720, P0725, P0740, P0741, P0745

DTC P0703: Malfunction of Stoplight Switch Stoplight switch system circuit DIAGNOSTIC FUNCTION TCM detects malfunction using the stoplight switch signal sent from the ETACS-ECU. DESCRIPTIONS OF MONITOR METHODS Drive the vehicle at 30 km/h (19 mph) or more for 10 seconds, and then turn the igni

 DTC C1035, C1041, C1042, C1043, C1044, C1046, C1047, C1048, C1049, C104B, C104F, C1053, C1057, C105F, C1063, C1067, C105B, C1200, C1204, C1208, C120C

DTC C1035 Mutual monitoring of RR wheel speed sensor CAUTION If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C − CAN Bus Line Diagnostic Flow). Whenever ECU is replaced, ensure that the CAN b

© 2010-2026 Copyright www.mioutlander.com