Mitsubishi Outlander: Automatic Transaxle and Propeller Shaft
Mitsubishi Outlander 2007-2013 Service Manual / Automatic Transaxle and Propeller Shaft
- CVT
- Diagnostic Function
- Diagnostic Trouble Code Procedures
- Symptom Procedures
- On-vehicle Service
- Transaxle Control
- Transaxle Assembly
- Continuously Variable Transaxle Overhaul
- Automatic Transaxle
- General Information
- Automatic Transaxle Diagnosis (A/T)
- Diagnosis S-AWC (Super All Wheel Control)
- On-vehicle Service
- Transaxle Control
- Transaxle Assembly
- Automatic Transaxle Overhaul
- Propeller Shaft
READ NEXT:
CVT
General Information
F1CJA, W1CJA model has been established.
TRANSAXLE
The transaxle consists of the torque converter and
gear train. The three-element, one-stage, two-phase
type torque converter wit
Diagnostic Function
WARNING INDICATOR
When any malfunction occurs in the items related to the CVT
system, which are described below, the symbol (A) continues
being displayed in the information screen in the multi informa
SEE MORE:
On-vehicle Service
WHEEL SPEED SENSOR OUTPUT CURRENT
MEASUREMENT
Required Special Tools:
MB991709: Wiring harness set
The relevant wheel, on which the wheel speed sensor is fitted,
should be free to run.
1. Remove the wheel speed sensor connector to be checked.
CAUTION
For precise measurement, do not connect to th
DTC B1C27, B1C28, B1C29, B1C2A, B1C2B, B1C2C, B1C2D, B1C2E
DTC B1C27: Side-air bag Module (LH) (Squib) System (Shorted to Squib
Circuit Ground)
Side-Airbag Module (Squib) (LH) Circuit
CAUTION
If DTC B1C27 is set in the SRS-ECU, always diagnose
the CAN bus lines.
CIRCUIT OPERATION
The SRS-ECU judges how severe a collision is
by detecting signals from t
© 2010-2025 Copyright www.mioutlander.com
