Mitsubishi Outlander manuals

Mitsubishi Outlander 2007-2013 Service Manual

Mitsubishi Outlander 2007-2013 Service Manual

Service and Repair Manual for secong generation Mitsubishi Outlander, model years 2007-2013. This manual provides explanations, etc. concerning procedures for the inspection, maintenance, repair and servicing of the subject model. Unless otherwise specified, each service procedure covers all models. Procedures covering specific models are identified by the model codes, or similar designation (engine type, transaxle type, etc.).

READ NEXT:

 General

 How To Use This Manual

MAINTENANCE, REPAIR AND SERVICING EXPLANATIONS This manual provides explanations, etc. concerning procedures for the inspection, maintenance, repair and servicing of the subject model. Unless otherwis

 How To Use Troubleshooting, Inspection Service Points

TROUBLESHOOTING CONTENTS DANGER The SRS-ECU adopts the rollover specification that the curtain airbag and seat belt pre-tensioner operate at the occurrence of rollover. Therefore, do not tilt the vehi

SEE MORE:

 Inspection Procedure 10-18

Inspection Procedure 10: The lock switch of the liftgate lock release handle does not perform the locking operation. CAUTION Before replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal. Liftgate Lock Release Handle Circuit PROBABLE

 DTC B1C33, B1C34, B1C35, B1C36, B1C38, B1C39, B1C3A, B1C3B

DTC B1C33: Driver's Lap Pre-tensioner (Squib) System (Shorted to Squib Circuit Ground) Driver's Lap pre-tensioner (Squib) Circuit CAUTION If DTC B1C33 is set in the SRS-ECU, always diagnose the CAN main bus line. CIRCUIT OPERATION The SRS-ECU judges how severe a collision is by detecting signals

© 2010-2024 Copyright www.mioutlander.com