Mitsubishi Outlander: Supplemental Restraint System (SRS)
Mitsubishi Outlander 2007-2013 Service Manual / Body, Exterior, Interior and Supplemental / Supplemental Restraint System (SRS)
- Specifications, General Information, Service Precautions
- SRS Air Bag Diagnosis
- Post-collision Diagnosis
- Air Bag Module(s) and Clock Spring
- Side Impact Sensor
- Curtain Air Bag Module(s)
- Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
READ NEXT:
Specifications, General Information, Service Precautions
Fastener Tightening Specifications
General Information
DANGER
The SRS-ECU adopts the rollover specification
that the curtain airbag and seat belt
pre-tensioner operate at the occurrence of
rollover.
SRS Air Bag Diagnosis
INTRODUCTION TO DIAGNOSIS
The SRS system is controlled by the SRS-ECU. The
SRS-ECU judges how severe a collision is by detecting
signals from the left and right front impact sensors
and side impact se
DTC B1206, B1207, B1B00, B1B01, B1B02, B1B03, B1B04, B1B05, B1B06, B1B07
DTC B1206: Passenger's Air Bag OFF Indicator Light (Open Circuit)
Air Bag OFF Indicator Light Drive Circuit
CAUTION
If DTC B1206 is set in the SRS-ECU, always diagnose
the CAN main bus line.
CIRCUIT
SEE MORE:
On-vehicle Service
BRAKE PEDAL INSPECTION
CAUTION
Do not apply grease or lubricant to the switch and the
switch installation section to avoid malfunction of the
switch. In addition, do not use gloves which have grease
on them.
BRAKE PEDAL HEIGHT CHECK
1. Turn up the floor carpet under the brake pedal.
2. Remove the s
Antenna
Roof antenna
To remove
Turn the pole (A) anticlockwise.
To install
Screw the pole (A) clockwise into the base (B) until it is securely retained.
NOTE:
● Be sure to remove the roof antenna in the following cases:
• When going into an automatic car wash.
• When placing a car cover
© 2010-2025 Copyright www.mioutlander.com
