Mitsubishi Outlander: General
- How To Use This Manual
- How To Use Troubleshooting, Inspection Service Points
- Vehicle Identification, General Data and Specifications
- Precautions Before Service
- Tightening Torque, Lubrication and Maintenance
- Maintenance Service
- Harness Connector Inspection (Electrical)
- How To Diagnose (Electrical)
READ NEXT:
How To Use This Manual
MAINTENANCE, REPAIR AND
SERVICING EXPLANATIONS
This manual provides explanations, etc. concerning
procedures for the inspection, maintenance, repair
and servicing of the subject model. Unless otherwis
How To Use Troubleshooting, Inspection Service Points
TROUBLESHOOTING CONTENTS
DANGER
The SRS-ECU adopts the rollover specification
that the curtain airbag and seat belt
pre-tensioner operate at the occurrence of
rollover. Therefore, do not tilt the vehi
Vehicle Identification, General Data and Specifications
Vehicle Identification
VEHICLE IDENTIFICATION NUMBER PLATE
VEHICLES IDENTIFICATION NUMBER LOCATION
The vehicle identification number (VIN) plate is located on a
plate attached to the left top side of
SEE MORE:
Water Hose and Water Pipe
REMOVAL AND INSTALLATION <2.4L ENGINE>
Pre-removal Operation
Engine Coolant Draining
Engine Upper Cover Removal
Air Cleaner Assembly Removal
Thermostat Removal
Post-installation Operation
Thermostat Installation
Air Cleaner Assembly Installation
Engine Upper Cover Installation
En
DTC P0053, P0068, P0069, P0101, P0102, P0103, P0106, P0107, P0108
DTC P0053: Linear Air-Fuel Ratio Sensor Heater Resistance
LINEAR AIR-FUEL RATIO SENSOR HEATER CIRCUIT
CIRCUIT OPERATION
Power is supplied from the MFI relay (terminal
No. 2) to the linear air-fuel ratio sensor heater.
The ECM (terminal No. 34) controls continuity to
the linear air-fuel ratio
© 2010-2026 Copyright www.mioutlander.com
