Mitsubishi Outlander: Heated seats*
The heated seats can be operated with the ignition switch in the “ON” position.
A– For driver’s switch
B– For passenger’s switch
1- Heater high (for quick heating)
2- Heater off
3- Heater low (to keep the
seat warm)
The indication lamp (C) will illuminate while the heater is on.
CAUTION
(1) Switch off seat heaters when not in use.
(2) Operate in the high position for quick heating. Once the seat is warm, set the heater to low to keep it warm. Slight variations in seat temperature may be felt while using the heated seats. This is caused by the operation of the heater’s internal thermostat and does not indicate a malfunction.
(3) If the following types of persons use the heated seats, they might become too hot or receive minor burns (red skin, heat blisters, etc.):
- Children, elderly or ill people
- People with sensitive skin
- Excessively tired people
- People under the influence of alcohol or sleep inducing medication (cold medicine, etc.)
(4) Do not use a blanket, cushion, or other material with high heat insulation properties on the seat while using the heater; this might cause the heater element to overheat.
(5) Turn the heater off immediately if it appears to be malfunctioning during use.
NOTE
(1) Do not place heavy objects on the seat or stick pins, needles, or other pointed objects into it.
(2) When cleaning the seat, do not use benzene, gasoline, alcohol, or other organic solvents; this might damage the surface of the seat, but also the heater element.
(3) If water or any other liquid is spilled on the seat, allow it to dry thoroughly before attempting to use the heater.
READ NEXT:
Seat belts
To protect you and your passengers in the event of an accident, it is the most
important that the seat belts are worn correctly when you drive.
The front seat belts have pre–tensioners. These bel
3–point type seat belt (with emergency locking mechanism)
This type of belt requires no length adjustment. Once worn, the belt adjusts
itself to the movement of the wearer, but in the event of a sudden or strong shock,
the belt automatically locks to res
Rear–centre three–point seat belt
The rear–centre three–point seat belt must be worn correctly as shown in the
illustration.
1. Pull the seat belt and fit tongue (A) into the black buckle (C). 2. Push
tongue (B) firmly in
SEE MORE:
Changing the time until “REST REMINDER” is displayed
The time until the display appears can be changed.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press t
For cold and snowy weather
Ventilation slots
The ventilation slots in front of the windscreen should be kept clear of leaves
or brushed clear after heavy snowfall, so that the operation of the heating and
ventilation systems will not be impaired.
Weatherstripping
To prevent freezing of the weatherstripping on the doors
