Mitsubishi Outlander: Odometer/Tripmeter
Each time you lightly press the multi-information meter switch, the display screen switches.
Odometer/Tripmeter 
→ Odometer/Tripmeter
→ Service reminder → Redisplay of a
warning display screen → Odometer/Tripmeter
Odometer
The odometer indicates the distance travelled.
Tripmeter
The tripmeter indicates the distance travelled between two points.
Example usage of tripmeter and tripmeter
It is possible to measure two currently
travelled distances, from home using tripmeter
and from a particular point on the
way using tripmeter .
To reset the tripmeter
To return the display to 0, hold down the multi-information meter switch for about 2 seconds or more. Only the currently displayed value will be reset.
Example
If tripmeter is displayed, only
tripmeter will be reset.
NOTE
• If there is no warning display, the switching sequence is: Odometer/Tripmeter
→ Odometer/ Tripmeter
→ Service reminder → Odometer/Tripmeter
.
• Both tripmeters and
can count up to 9999.9 km (9999.9 miles).
When a tripmeter goes past 9999.9 km (9999.9 miles), it returns to 0.0 km (0.0 miles).
• When disconnecting the battery terminal, the memories of tripmeter display
and display
are erased, and their displays return
to 0.0 km (0.0 miles).
Service reminder
This displays the distance and number of months until the next periodic inspection.
Refer to “Service reminder”.
READ NEXT:
Interrupt display screen (when the ignition switch or the operation mode is
OFF)
When there is information to be announced, such as lamp reminders, the buzzer
sounds and the multiinformation display switches to the warning display screen.
Refer to the appropriate page and take
Door ajar warning display screen (when the ignition switch or the
operation mode
is OFF)
If any of the doors or the tailgate is not completely closed, this displays the
open door or tailgate.
1- Doors and tailgate are closed
2- Doors or tailgate are open
Information screen (when the ignition switch is turned from the “LOCK”
position to
the “ON” position or the operation mode is changed from OFF to
ON)
When the ignition switch is turned to the “ON” position or the operation mode
is put in ON, the display screen switches in the following order.
1- Screen when the ignition switch or the opera
SEE MORE:
Modification/alterations to the electrical orfuel systems
MITSUBISHI MOTORS CORPORATION has always manufactured safe, high quality vehicles.
In order to maintain this safety and quality, it is important that any accessory
that is to be fitted, or any modifications carried out which involve the electrical
or fuel systems, should be carried out in acco
If the vehicle breaks down
If the vehicle breaks down on the road, move it to the shoulder and turn on the
hazard warning flashers and set up a warning triangle, flashing lamp, etc.
Refer to “Hazard warning flasher switch”.
If the engine stops/fails
Vehicle operation and control are affected if the engine stops. Befo
