Mitsubishi Outlander manuals

Mitsubishi Outlander: Reversing sensor system operation indication lamp

Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Starting and driving / Reversing sensor system / Reversing sensor system operation indication lamp

In case there is a malfunction in the reversing sensor system, the reversing sensor system operation indication lamp will blink and the warning buzzer will sound for approximately 5 seconds. Even after the buzzer has stopped sounding, the indication lamp will continue flashing until the system reverts to the normal state. Have the vehicle inspected at a MITSUBISHI MOTORS Authorized Service Point.

Rear-view camera

READ NEXT:

 Rear-view camera

The rear-view camera is a system that shows the view behind the vehicle on a screen in the centre panel. CAUTION • The rear-view camera is an assistance system that enables the driver to chec

 Cargo loads

Cargo loads precautions CAUTION • Do not load cargo or luggage higher than the top of the seatback. Be sure that your cargo or luggage cannot move once your vehicle is moving. Having the driver

 Trailer towing

In order to tow a trailer with your vehicle, have a trailer towing device that meets all relevant regulations in your area, mounted consult a MITSUBISHI MOTORS Authorized Service Point. The regul

SEE MORE:

 Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped with high intensity discharge headlamps)

1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle. : Front of the vehicle 2. Turn the cap (B) anticlockwise to remove it. : Front of the vehicle 3. Turn the bulb (C) antic

 Removing and installing the battery upper cover (Petrol-powered vehicles equipped with turbocharger)

Warning ► Turn the ignition key to the “LOCK” position on the vehicle. Make sure that your clothes cannot be caught by the fan or drive belt. Personal injury could result. To remove 1. Remove the clips (A), and then remove the air duct (B). 2. Turn the plastic nuts (C) anticlockwi

© 2010-2026 Copyright www.mioutlander.com