Mitsubishi Outlander: Seat belt inspection
• Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic parts. Replace the belt assembly if it is defective.
• A dirty belt should be cleaned with neutral detergent in warm water. After rinsing in water, let it dry in the shade. Do not attempt to bleach or re-dye the belts because this will affect their characteristics.
WARNING
• We recommend you to have all seat belt assemblies including retractors and attaching hardware inspected after any collision.
We recommend that seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.
• Do not attempt to repair or replace any part of the seat belt assemblies; we recommend you to have this work done by a MITSUBISHI MOTORS Authorized Service Point. Incorrect repair or replacement could reduce the effectiveness of the belts and could result in serious injury in the event of a collision.
• Once the pretensioner has been activated, it cannot be re-used.
It must be replaced together with the retractor.
READ NEXT:
Supplemental restraint system (SRS) - airbag
The information for SRS airbags includes important information concerning the
driver’s and front passenger’s airbags, the driver’s knee airbag, the side airbags
and the curtain airbags.
The
How the Supplemental Restraint System works
The SRS includes the following components:
1- Airbag module (Driver)
2- Front passenger’s airbag OFF indication lamp
3- Airbag module (Passenger)
4- Driver’s knee airbag module*
5- Front pa
Caution for installing the child restraint on vehicles with a front
passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
WARNING
• Extreme Hazard! Do not use a rearward facing child restraint on a seat protected
by an airbag in front of
SEE MORE:
Bonnet
To open
1. Pull the release lever towards you to unlock the bonnet.
2. Raise the bonnet while pressing the safety lock.
NOTE
• Only open the bonnet when the wipers are in the parked position. In any other
position, the wipers could damage the paint or bonnet.
3. Support the bonnet by i
Snow tyres
The use of snow tyres is recommended for driving on snow and ice. To preserve
driving stability, mount snow tyres of the same size and tread pattern on all 4
wheels.
Snow tyres worn more than 50% are no longer suitable for use as snow tyres.
Snow tyres which do not meet specifications must not
