Mitsubishi Outlander: Accessory socket
CAUTION
• Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or less.
When using more than one socket at the same time, make sure that the electrical accessories are 12 V accessories and that the total power consumption does not exceed 120 W.
• Long use of the electric appliance without running the engine may run down the battery.
• When the accessory socket is not in use, be sure to close the lid or install the cap, because the socket might become clogged by foreign material and be short-circuited.
To use a plug-in type accessory, open the lid or remove the cap, and insert the plug in the accessory socket.
NOTE
• Accessory sockets in 2 locations can be used at the same time.
The accessory socket can be used while the ignition switch or the operation mode is in ON or ACC.
READ NEXT:
Interior lamps
1- Luggage room lamp
2- Room lamp (rear)*
3- Map & room lamps (front) Sunshade illumination dimming control switch*
NOTE
• If you leave the lamps on without running the engine, you will r
Storage spaces
CAUTION
• Never leave lighters, cans of carbonated drink, and spectacles in the cabin
when parking the vehicle in hot sunshine. The cabin will become extremely hot, so
lighters and other flamm
Cup holder
CAUTION
• Do not drink beverages while driving.
This is distracting and could cause an accident.
For the front seat
The cup holders are located in front of the floor console box.
For the rea
SEE MORE:
The Look
The current-generation Lancer sedan has been sold since early 2007. (See a
side-by-side comparison of the 2010 Lancer Sportback and sedan.) Mitsubishi has
resurrected the Sportback name for 2010, but the new model looks completely
different from the one sold in the U.S. as a 2004 model. Wherea
Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
► Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and rear
hatch are closed, after which the system preparation mode will
