Mitsubishi Outlander: Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
► Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and rear
hatch are closed, after which the system preparation mode will once again go into
effect.)
► Turning the ignition switch to the “ON” position.
► Holding the keyless operation key and locking and unlocking the doors and the rear hatch using the keyless operation function (vehicles equipped with the keyless operation system).
Note
► When the ignition switch is turned to the “ON” position, the buzzer sounds
4 times.
This operation indicates that the alarm was activated while the vehicle was parked.
Please check the inside of the vehicle to confirm that nothing was stolen.
► Even if the battery is disconnected, the alarm activation memory will not be erased.
READ NEXT:
Electric window control
The electric windows can only be operated with the ignition switch in the “ON”
position.
Electric window control switch
Each door window opens or closes while the corresponding switch is operated.
1- Driver’s door window
2- Front passenger’s door window
3- Rear left door window
4- Rear right door window
5- L
Driver’s switches
The driver’s switches can be used to operate all door windows. A window can be
opened or closed by operating the corresponding switch.
Press the switch down to open the window, and pull up the sw
SEE MORE:
Mark display screen (when the ignition switch is “ON”)
This is displayed when you press the multi- information meter switch and switch
the warning display screen.
This mark is also displayed if there is another warning other than the one displayed.
When the cause of the warning display is eliminated, the
mark goes out automatically.
Note
Information screen (when the ignition switch is “OFF“)
Each time you lightly press the multi-information meter switch, the display screen
switches in the following order.
1- Odometer (Type 1)/Tripmeter
2- Odometer (Type 1)/Tripmeter
3- Service reminder
4- Redisplay of a warning display screen
