Mitsubishi Outlander: Mark display screen (when the ignition switch is “ON”)
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Mark display screen (when the ignition switch is “ON”)
This is displayed when you press the multi- information meter switch and switch the warning display screen.
This mark is also displayed if there is another warning other than the one displayed.
When the cause of the warning display is eliminated, the
mark goes out automatically.
Note
► When the mark is displayed, the
warning display screen can be redisplayed on the information screen.
Refer to “Information screen (when the ignition switch is “OFF“)”.
Refer to “Information screen (when the ignition switch is “ON”)”.
READ NEXT:
Active Stability Control (ASC) OFF display screen
This is displayed when the Active Stability Control (ASC) is turned off with
the ASC OFF switch.
If there is a fault with the ASC, the ASC OFF display is shown.
Refer to ““ASC OFF” switch
Information screen (when the ignition switch is “ON”)
Each time you lightly press the multi-information meter switch, the display screen
switches in the following order.
1- Odometer (Type 1)/Tripmeter
2- Odometer (Type 1)/Tripmeter
3- Service re
Odometer/Tripmeter
The operation method is the same as when the ignition switch is “OFF”.
Refer to “Odometer/Tripmeter” for further details.
SEE MORE:
Interior lamps
1- Cargo room lamp
2- Rear room lamp
3- Front room & map lamps
Note
► If you leave the interior lamps on without running the engine, you will run
down the battery.
Before you leave the vehicle, make sure that all the interior lamps are off.
Towing
Caution
► When towing the vehicle with only the front wheels or only the rear wheels
raised off the ground, do not place the ignition switch in the “ON” position. Placing
the ignition switch in the “ON” position could cause the ASC to operate, resulting
in an accident.
Note th
© 2010-2025 Copyright www.mioutlander.com
