Mitsubishi Outlander: Gearshift lever position display
When the ignition switch is turned to the “ON” position, the position of the gearshift lever is indicated in the multi-information display.
In addition, when the vehicle is driven with the gearshift lever in the “D” (DRIVE) position, the forward gear number is shown.
If the gearshift lever position display
blinks and the buzzer beeps
With the gearshift lever in the “R” (REVERSE) position, if the gearshift lever
position display blinks and the buzzer
beeps, the transmission gears have not properly engaged. To correct this situation,
the following procedure must be performed.
1. Depress the brake pedal with your right foot and place the gearshift lever
in the “N” (NEUTRAL) position.
2. Again place the gearshift lever in the “R” (REVERSE) position and confirm that
the gearshift lever position display has stopped blinking and that the buzzer has
stopped beeping.
3. Repeat 1 and 2 above if the gearshift lever position display continues to blink
and the buzzer beeps.
Warning
► To avoid unintended vehicle movement when the gearshift lever position display
blinks and the buzzer beeps,
keep brake pedal applied with your right foot and do not depress the accelerator
pedal.
When the gearshift lever position display is not showing
There may be a problem in the Twin Clutch SST.
If this occurs, the safety device operates and prevents the vehicle from moving. Perform the following procedure.
1. Park your vehicle in a safe place and stop the engine.
2. Restart the engine.
If the gearshift lever position display is shown and the vehicle can move after this procedure is performed, there is no malfunction.
If the gearshift lever position display is not shown and the vehicle cannot move, or if this problem occurs repeatedly, have the vehicle checked by a MITSUBISHI MOTORS Authorized Service Point as soon as possible.
READ NEXT:
Gearshift lever positions (Manual shift gate)
“P” PARK
This position locks the transmission to prevent the vehicle from moving. The
engine can be started in this position.
“R” REVERSE
This position is to back up.
Caution
► N
Twin Clutch SST control mode
Select the control mode from the following two types to suit the driving conditions.
Note
► When continuously driving on closed circuit tracks or at other locations where
the engine is op
Twin Clutch SST control mode
When the ignition switch is set to the “ON” position, operate the Twin Clutch
SST control mode switch (A) to change the control mode.
When the engine is started, the control mode is automatic
SEE MORE:
To operate using the keyless operation function
Locking the doors and tailgate
When you are carrying the keyless operation key, if you press the driver’s or
front passenger’s door lock/unlock switch (A), or the tailgate LOCK switch (B) within
the operating range, the doors and the tailgate are locked.
The turn-signal lamps will blink on
Wiper deicer switch
The rear window demister switch can be operated when the engine is running.
When the front wipers have frozen to the windscreen at the parked positions,
turning on this switch will heat the windscreen to make the wipers operable. Press
the switch and the deicer will operate and turn on the in
