Mitsubishi Outlander: Wiper deicer switch
Mitsubishi Outlander 2007-2013 Owner's Manual / Instruments and controls / Wiper deicer switch
The rear window demister switch can be operated when the engine is running.
When the front wipers have frozen to the windscreen at the parked positions, turning on this switch will heat the windscreen to make the wipers operable. Press the switch and the deicer will operate and turn on the indicator lamp (A).
NOTE:
● The switch is automatically turned off after operating for approximately 20 minutes. To turn off the switch while it is operating, press the switch again.
READ NEXT:
Rear window demister switch
The rear window demister switch can be operated when the engine is running.
Push the switch to turn on the rear window demister. It will be turned off automatically
in about 20 minutes. To turn o
Horn switch
Press the steering wheel on or around the
mark
SEE MORE:
Central door locks
Vehicles without the keyless entry system and vehicles without the keyless
operation system
Using the key on driver’s door locks or unlocks driver’s doors and the tailgate.
1- Lock.
2- Unlock.
NOTE:
● If the vehicle has a Dead Lock System and the Dead Lock System is set, turning
DTC B2204, B2206, B2352, B2416, C1608, C1910, C1920, C1930, C1940, C1911,
C1921, C1931, C1941, C1912, C1922, C1932, C1942, C1913, C1923, C1933, C1943,
C1914, C1924, C1934, C1944
DTC B2204: Coding data mismatch
CAUTION
When DTC B2204 is set, be sure to diagnose
the CAN bus line.
When replacing the ECU, always check that
the communication circuit is normal.
DTC SET CONDITION
If the vehicle information data transmitted from the
ETACS-ECU via the CAN bus lines is differen
© 2010-2026 Copyright www.mioutlander.com
