Mitsubishi Outlander: Rear window demister switch
The rear window demister switch can be operated when the engine is running.
Push the switch to turn on the rear window demister. It will be turned off automatically in about 20 minutes. To turn off the demister within about 20 minutes, push the switch again.
The indicator lamp (A) will illuminate while the demister is on.
NOTE:
● When the rear window demister switch is pressed, the outside rearview mirrors are defogged or defrosted. Refer to “Heated mirror”.
● When the rear window demister switch is pushed, the window glass becomes warm and the wipers become operable. Refer to “Wiper deicer switch”.
● The demister switch is not to melt snow but to clear mist.
Remove snow before use of the demister switch.
● When cleaning the inside of the rear window, use a soft cloth and wipe lightly along the heater wires, being careful not to damage the wires.
● Do not allow objects to touch the inside of the rear window glass, damaged or broken wires may result.
READ NEXT:
Horn switch
Press the steering wheel on or around the
mark
Economical driving
For economical driving, there are some technical requirements that have to be
met. The prerequisite for low fuel consumption is a properly adjusted engine. In
order to achieve longer life of the v
SEE MORE:
DTC B2352, B2400, B2401, B2402, B2403, B2404, B2405, B2406, B2407, B2408, B2409,
B240A, B240B, B240C, B240D, B240E
DTC B2352: Antenna fail
CAUTION
When replacing the ECU, always check that the
communication circuit is normal.
Receiver Antenna Module and KOS-ECU Circuit
DTC SET CONDITION
If an open circuit or short to ground occurs in the
antenna, KOS-ECU sets the DTC B2352.
TECHNICAL DESCRIPTION (COMMENT)
When
DTC B1731, B1761, B1A08, B1A09, B1A0A, B1A0B, B1A10, B1A11, B1A12, B1A13,
B1A24, B1A25, B1A28, B1A35, B2101, B2102, B2204, B2206
DTC B1731: Engine Control Module communication timeout
CAUTION
When the DTC B1731 is set, be sure to diagnose
the CAN bus line.
When replacing the ECU, always check that
the communication circuit is normal.
DTC SET CONDITION
KOS-ECU checks that the Engine Control Module
data has been received
