Mitsubishi Outlander: Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
• Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and the tailgate are closed, after which the system preparation mode will once again go into effect.)
• Turning the ignition switch to the “ON” position (except for vehicles equipped with the keyless operation system).
• Putting the operation mode in ON (vehicles equipped with the keyless operation system).
• Holding the keyless operation key and locking and unlocking the doors and the tailgate using the keyless operation function (vehicles equipped with the keyless operation system).
NOTE
• When the ignition switch is turned to the “ON” position or the operation mode is put in ON, the buzzer sounds 4 times. This operation indicates that the alarm was activated while the vehicle was parked.
Please check the inside of the vehicle to confirm that nothing was stolen.
• Even if the battery is disconnected, the alarm activation memory will not be erased.
READ NEXT:
Electric window control
The electric windows can only be operated with the ignition switch in the “ON”
position or the operation mode in ON.
WARNING
• Before operating the electric window control, make sure that n
Sunshade
WARNING
• Never leave a child (or other person who might not be capable of safe operation
of the sunshade switch) in the vehicle alone.
• Before operating the sunshade, make sure that nothing
SEE MORE:
Mark display screen (when the ignition switch is “ON”)
This is displayed when you press the multi- information meter switch and switch
the warning display screen.
This mark is also displayed if there is another warning other than the one displayed.
When the cause of the warning display is eliminated, the
mark goes out automatically.
Note
Radio data system (RDS)
1 - AM/FM (FM/MW/LW selection) button
2 - PWR (On-Off) switch
3 - CT (Clock time) indicator
4 - RDS (Radio data system) indicator
5 - TP (Traffic program identification) indicator
6 - PTY (Program type) indicator
7 - REG (Regional program) indicator
8 - Display
9 - Memory select buttons
1
