Mitsubishi Outlander: Changing a fuse
1. Before replacing a fuse, always turn off the electrical circuit concerned
and turn the ignition key to the “LOCK” position.
2. Remove the fuse box cover.
3. Referring to the fuse load capacity table, check the fuse pertaining to the problem.
A - Fuse is OK
B - Blown fuse
4. There is a fuse removing tool in the fuse cover of the passenger compartement. First take the fuse removing tool out of the fuse cover slowly and then by using the fuse removing tool, pull the fuse straight out from the fuse box. If it is not blown, something else must be causing the problem; contact an authorized MITSUBISHI dealer to have the problem checked.
5. Insert a new fuse of the same capacity into the clip and insert the fuse at the same place in the fuse box.
CAUTION
(1) If the newly inserted fuse blows again after a short time, have the
electrical system checked and repaired by an authorized MITSUBISHI dealer to find
the cause and rectify it.
(2) Never use a fuse with a capacity larger than that
specified or any substitute, such as wire, foil, etc.; doing so will cause the circuit
wiring to heat up and could cause fire.
READ NEXT:
Replacement of lamp bulbs
Before replacing a bulb, ensure the lamp is off. Do not touch the glass part
of the new bulb with your bare fingers; the skin oil left on the glass will evaporate
when the bulb gets hot and the va
Headlamps and position lamps
Remove the sealing cover by turning it anticlockwise and disconnect the connector.
Headlamps
Unhook the spring which secures the bulb, and then remove the bulb.
CAUTION
Never hold the halogen lamp bulb with a bare hand, dirty glove, etc. The
oil from your hand could cause the bulb to
SEE MORE:
Engine coolant
To check the coolant level
A transparent coolant reserve tank (A) is located in the engine compartment.
The coolant level in this tank should be kept between the “LOW” and “FULL” marks
when measured while the engine is cold.
To add coolant
The cooling system is a closed system and no
The side airbags and curtain airbags ARE DESIGNED TO DEPLOY when…
The side airbags and curtain airbags are designed to deploy when the vehicle
suffers a moderate-tosevere side impact to the middle of the passenger compartment.
The typical condition is shown in the illustration.
The seat belts in your vehicle are your primary means of protection in a collisio
