Mitsubishi Outlander: Combination headlamps, dipper and turn signal switch
Headlamps
Rotate the switch to turn on the lamps.
–All lamps off
–Position, tail, licence–plate, and
instrument panel lamps on
–Headlamps on and other lamps remain
on
Lamp monitor system
If the driver’s door is opened when the key is in the “LOCK” or “ACC” position or removed from the ignition switch with the lamp switch in the “ ” or “ ” position, a buzzer will sound to remind the driver to turn off the lamps.
Turn off the lamp switch, and the buzzer will stop.
[Vehicles with Daytime Running Lamp]
When the ignition key is in the “ON” position and the lamp switch is set to the
“” position, the low beam of the headlamps,
tail lamps, etc., will illuminate.
NOTE
(1) Do not leave the headlamps and other lamps on for too long time while
the engine is stationary. A run–down battery could result.
(2) When it rains,
or when the vehicle has been washed, the inside of the lens sometimes becomes foggy.
This is the same phenomenon as when window glass mists up on a humid day, and does
not indicate a functional problem. When the lamp is switched on, the heat will remove
the fog. However, if water gathers inside the lamp, please go to an authorized MITSUBISHI
dealer for a check.
Dipper (High/Low beam change)
When the lamp switch is in the “
”
position, the beam changes from high to low (or low to high) each time the lever
is pulled to (1). While the high beam is on, the high beam indication lamp in the
instrument cluster will also illuminate.
Headlamp flasher
The high beams flash when the lever is pulled slightly to (2), and will go off when it is released.
When the high beam is on, the high beam indication lamp in the instrument cluster will also illuminate.
NOTE
The high beams can also flash when the lamp switch is OFF.
READ NEXT:
Turn/lane-change signals
The turn-signal lamps flash when the switch is operated (with the ignition switch
“ON”). At the same time, the turn signal indicator flashes.
1- Turn-signals
When making a normal turn, use p
Headlamp levelling switch
The angle of the headlamp beam varies depending upon the load carried by the
vehicle.
The headlamp levelling switch can be used to adjust the headlamp illumination
distance (when the lower beam
Windscreen wiper and washer switch
The windscreen wiper and washer can be operated with the ignition switch in the
“ON” or “ACC” position. Move the switch to operate the windscreen wipers or spray
the washer fluid.
SEE MORE:
To unlock the doors and rear hatch
You can select the function to unlock the doors and rear hatch either using the
ignition switch position or using the selector lever position (CVT) or the gearshift
lever position (Twin Clutch SST).
These functions are not activated when the vehicle is shipped from the factory.
To activate or
Driving, alcohol and drugs
Drunk driving is one of the most frequent causes of accidents.
Your driving ability can be seriously impaired even with blood alcohol levels
far below the legal minimum. If you have been drinking, don’t drive. Ride with a
designated non-drinking driver, call a cab or a friend, or use public t
