Mitsubishi Outlander: Daytime dipper button (meter illumination control)
Each time you press this button, there is a sound and the brightness of the instruments changes.
NOTE
• You can adjust to 8 different levels for when the position lamps are illuminated and 8 for when they are not.
• When the lamp switch is in a position other than the “OFF” position, the meter illumination switches automatically to the adjusted brightness, depending on the brightness outside the vehicle.
• The brightness level of the instruments is stored when the ignition switch is turned to the “OFF” position or the operation mode is put in OFF.
• If you press and hold the button for longer than about 1 second when the position lamps are illuminated, the brightness level changes to the maximum level. Pressing and holding the button for longer than about 1 second again returns the brightness level to the previous level.
1- Brightness display
2- Rheostat illumination button
READ NEXT:
Multi-information display
Always stop the vehicle in a safe place before operating.
The following information is included on the multi-information display: warnings,
odometer, tripmeter, service reminder, engine coolant tem
Multi-information meter switch
Each time the multi-information meter switch is operated, a sound is emitted
and the multi-information display changes between information such as warnings,
odometer (Type 1), tripmeter, service r
Information screen (when the ignition switch or the operation mode is OFF)
Each time you lightly press the multi-information meter switch, the display screen
switches in the following order.
1- Odometer (Type 1)/Tripmeter
2- Odometer (Type 1)/Tripmeter
3- Servic
SEE MORE:
Sunroof
Sunroof
The sunroof can only be operated with the ignition switch in the “ON” position.
1- Open.
2- Tilt up.
3- Close, Tilt down.
To open, press the switch (1)
To stop the moving sunroof, press the switch (2) or (3).
NOTE:
● The sunroof automatically stops just before reaching th
Drive mode indicator display screen
This displays the 4WD status.
If you select “4WD LOCK” mode with the drive mode selector, “4WD LOCK” is displayed;
if you select “4WD AUTO” mode, “4WD” is displayed.
Nothing is displayed when 2WD mode is selected.
Refer to “Drive mode selector”.
mark display screen (w
