Mitsubishi Outlander: Error codes (USB memory device)
Mitsubishi ASX / Mitsubishi ASX Owner's Manual / For pleasant driving / Error codes (USB memory device)
If an error code appears in the display, take action in accordance with the table below.
READ NEXT:
Handling of compact discs
• Use only the type of compact discs that have the mark shown in the illustration
below.
(Playback of CD-R or CD-RW discs may cause problems.)
• The use of special shaped, damaged compact di
Antenna
To remove
Turn the pole (A) anticlockwise.
To install
Screw the pole (A) clockwise into the base (B) until it is securely retained
NOTE
• Be sure to remove the roof antenna in the following
Digital clock
Automatic mode and manual mode is available for digital clock adjustment.
Select the automatic mode or the manual mode by performing the following operations:
A- PWR switch
B- TUNE switch
1. Pre
SEE MORE:
Twin Clutch SST control mode
When the ignition switch is set to the “ON” position, operate the Twin Clutch
SST control mode switch (A) to change the control mode.
When the engine is started, the control mode is automatically set to the “NORMAL”
mode. Use the following procedures to change the control mode.
To sh
To enter frequencies into the memory
Manual setting
You can assign to the memory select buttons (3) a maximum of 18 stations in the
FM band (6 FM1, 6 FM2 and 6 FM3 stations) and 6 stations each in the MW and LW band.
(Stations already assigned to the memory select buttons are replaced by any newly
assigned stations.)
Follow t
© 2010-2025 Copyright www.mioutlander.com
