Mitsubishi Outlander manuals

Mitsubishi Outlander: Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)

Do not attempt to disassemble or repair headlamps, and do not attempt to replace their bulbs.

► A high voltage is present in the power circuit and in the bulbs and bulb Warning

► A high voltage is present in the power circuit and in the bulbs and bulb terminals.
To avoid the risk of an electric shock, contact a MITSUBISHI MOTORS Authorized Service Point whenever repair or replacement is necessary.

READ NEXT:

 Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped with high intensity discharge headlamps)

1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle. : Front of the vehicle 2

 Position lamps (except for vehicles equipped with high intensity discharge headlamps)

1. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the left side, remove the bolt (A) holding down the relay box and move the relay box towards the rear of the v

 Position lamps (for vehicles equipped with high intensity discharge headlamps)

1. To create enough work space, turn the steering wheel all the way in the direction opposite to the side you wish to replace. 2. Remove the clips (A) and screws (B) to turn up the cover (C).

SEE MORE:

 Lamps (headlamps, fog lamp, etc.) auto- cutout function

► If, while the lamp switch is in the “ ” position, the ignition switch is turned to the “LOCK” position or “ACC” position, or the key is removed from the ignition switch, the lamps automatically go out when the driver’s door is opened. [When the engine was started using the

 Operation of the automatic transmission INVECS-II

CAUTION (1) Before selecting a gear with the engine running and the vehicle stationary, fully depress the brake pedal to prevent the vehicle from creeping. The vehicle will begin to move as soon as the gear is engaged, especially when the engine speed is high, at fast idle or with the air con

© 2010-2026 Copyright www.mioutlander.com