Mitsubishi Outlander: If the keyless operation key is not operating properly
Insert the keyless operation key into the key slot in the glove box. Starting the engine and changing the operation mode should now be possible.
Remove the keyless operation key from the key slot after starting the engine or changing the operation mode.
NOTE
• Do not insert into the key slot anything other than the keyless operation key.
This could cause damage or a malfunction.
• Remove the object or additional key from the the keyless operation key before
inserting the key into the key slot.
The vehicle may not be able to receive the registered ID code from the registered key.
Therefore, the engine may not start and the operation mode may not change.
Keyless operation key reminder
If the operation mode is in OFF and the driver’s door is opened with the keyless operation key in the key slot, a warning is issued with the warning display and the buzzer buzzing for approximately 3 seconds to remind you to remove the key.
READ NEXT:
To operate without using the keyless operation function
Emergency key
The emergency key is built into the keyless operation key. If the keyless operation
function cannot be used, for example because the keyless operation key battery has
worn out or th
Keyless entry system
Press the remote control switch, and all doors and the tailgate will be locked
or unlocked as desired. It is also possible to operate the outside rear-view mirrors.
1- LOCK () switch
2- UNLOCK
Doors
CAUTION
• Make sure the doors are closed: driving with doors not completely closed
is dangerous.
• Never leave children in the vehicle unattended.
• Be careful not to lock the doors while
SEE MORE:
Caution for installing the child restraint on vehicles with a front passenger
airbag
The label shown here is attached on vehicles with a front passenger airbag.
Warning
► Extreme Hazard!
Do not use a rearward facing child restraint on a seat protected by an airbag in
front of it!
Use rearward facing child restraints in the rear seat or turn off the front passenger’s
To decrease the set speed
There are 2 ways to decrease the set speed.
“COAST SET” switch
Press and hold the “COAST SET” switch (B) while driving at the set speed, and
your speed will slow down gradually.
When you reach your desired speed, release the switch. Your new cruising speed
is now set.
To slow down
