Mitsubishi Outlander child restraint top tether strap routed over the rear seatback and connected to the anchor point

WARNING

  • Child restraint anchors are designed to withstand only the forces applied by a correctly fitted child restraint. Never use these anchors to attach adult seat belts, secure cargo or connect other equipment to the vehicle. Improper use may damage the anchor and prevent a child restraint from being installed securely. A child attached to a damaged or improperly used anchor could be seriously injured or killed in a collision.

The child restraint top tether strap must be used when a compatible forward-facing child restraint is installed with the vehicle seat belt in an applicable Mitsubishi Outlander rear seating position.

Begin by installing and securely tightening the child restraint with the seat belt according to the appropriate procedure and the restraint manufacturer's instructions.

1. Remove the head restraint if necessary to obtain the correct child restraint fit, and store it securely where it cannot move around inside the vehicle. Reinstall the head restraint after the child restraint has been removed.

2. Route the top tether strap over the seatback as specified by the child restraint manufacturer. Make sure the strap is not twisted, trapped or routed around an unsuitable part of the seat.

3. Attach the top tether hook securely to the designated tether anchor point identified in the illustration. Use only the anchor assigned to the seating position where the child restraint is installed.

4. Complete the applicable child restraint installation steps described in this section before tightening the top tether strap. Remove slack according to the restraint manufacturer's instructions without changing the position of the child restraint.

If you have questions about routing or securing a top tether strap in the Mitsubishi Outlander, Mitsubishi Motors recommends visiting an authorized Mitsubishi Motors dealer for assistance.

    READ NEXT:

     Booster seats

    Precautions on booster seats WARNING If a booster seat or vehicle seat belt is used incorrectly, the risk of serious injury or death to the child during sudden braking or a collision increases si

     Supplemental Restraint System (SRS)

     Precautions on SRS

    This section explains important safety information about the Supplemental Restraint System fitted to the Mitsubishi Outlander, including the airbags and seat belt pretensioners designed to provide add

    SEE MORE:

     Front and second row seat-mounted side airbag, front seat-mounted center airbag and side curtain SRS airbag systems

    The front and second-row seat-mounted SRS side airbags are installed in the outer sides of the applicable front and second-row seatbacks. The front seat-mounted SRS center airbag is located on the right side of the driver's seatback, while the Side Curtain SRS airbags are housed along the sid

     Amplifier

    The amplifier is installed beneath the floor of the vehicle. FCC Notice: For USA: AMPL UNIT-PRE MAIN Model: P2302 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device mus