Mitsubishi Outlander: Procedure for replacing the remote control switch battery
1. Remove the screw (A) from the remote control switch.
2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight blade (or minus) screwdriver into the notch in the remote control switch case and use it to open the case.
NOTE
• Be sure to perform the procedure with the MITSUBISHI mark facing you. If the MITSUBISHI mark is not facing you when you open the remote control switch case, the switches may come out.
3. Remove the remote control transmitter from the remote control switch case. Then, open the remote control transmitter using the method described in step 2.
4. Remove the old battery.
5. Install a new battery with the + side (B) down.
6. Close the remote control transmitter firmly.
7. Place the remote control transmitter in the remote control switch case, then
securely close the remote control switch case.
8. Attach the screw (A) removed in step 1.
9. Check the keyless entry system to see that it works.
NOTE
• You may purchase a replacement battery at an electric appliance store.
• A MITSUBISHI MOTORS Authorized Service Point can replace the battery for you
if you prefer.
CAUTION
• When the remote control switch case is opened, be careful to keep water, dust, etc. out. Also, do not touch the internal components.
READ NEXT:
Keyless operation system
The keyless operation system allows you to lock and unlock the doors and tailgate,
start the engine and change the operation mode simply by carrying the keyless operation
key with you.
The keyles
Operating range of the keyless operation system
If you are carrying the keyless operation key, enter the operating range of the
keyless operation system, and press the driver’s or front passenger’s door lock/unlock
switch, the tailgate LOCK
To operate using the keyless operation function
Locking the doors and tailgate
When you are carrying the keyless operation key, if you press the driver’s or
front passenger’s door lock/unlock switch (A), or the tailgate LOCK switch (B) withi
SEE MORE:
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
→ “GRAVEL” → “SNOW” → “TARMAC”.
Note
► The control mode can be
The side airbags and curtain airbags ARE DESIGNED TO DEPLOY when…
The side airbags and curtain airbags are designed to deploy when the vehicle
suffers a moderate-tosevere side impact to the middle of the passenger compartment.
The typical condition is shown in the illustration.
The seat belts in your vehicle are your primary means of protection in a collisio
