Mitsubishi Outlander: Rear fog lamp switch
The rear fog lamp can be operated when the headlamps or front fog lamps (if so equipped) turn on.
Push the switch to turn on the gear fog lamp, and push the switch again to turn it off. The indication lamp in the instrument cluster will illuminate while the rear fog lamp is on.
NOTE
(1) The rear fog lamp is automatically turned off when the headlamps and front
fog lamps (if so equipped) turned off.
To turn on the rear fog lamp again, push
the switch again when the headlamps or front fog lamps (if so equipped) turn on.
(2) In case of vehicles with Daytime Running Lamp, the front fog lamp can be operated
even if the lamp switch is set to the “
”
(OFF) position, because the low beam of the headlamps, tail lamps, etc. illuminate
when the ignition key is at the “ON” position.
(3) The rear fog lamp is installed
only on the driver’s side.
READ NEXT:
Rheostat (meter illumination control)
The rheostat can be adjusted while the lamp switch is “”
or “”. Turn the dial to adjust the meter
illumination to the desired brightness.
1- To increase brightness 2- To reduce brightne
Horn switch
When the ignition switch is in the “ON” or “ACC” position, pressing the “”
mark on the steering wheel, causes the horn to sound.
SEE MORE:
To adjust forward or backward
Lift the seat adjusting lever and adjust the seat forward or backward to the
desired position. After adjustment, release the adjusting lever to lock the seat
in position.
WARNING
To ensure the seat is locked securely, attempt to move the seat forward
or backward without using the lever.
Starting and stopping the
Tips for starting
• The operation mode can be in any mode to start the engine.
• The starter motor will be turning for up to approximately 15 seconds if the
engine switch is released at once. Pressing the engine switch again while the starter
motor is still turning will stop the starter
