Mitsubishi Outlander manuals

Mitsubishi Outlander: Rear window wiper and washer

The rear window wiper and washer switch can be operated with the ignition switch or the operation mode in ON or ACC.

INT- The wiper operates continuously for several seconds then operates intermittently

INT- The wiper operates continuously for several seconds then operates intermittently at intervals of about every 8 seconds

OFF- Off

The washer fluid will be sprayed onto the rear window when the knob is turned

The washer fluid will be sprayed onto the rear window when the knob is turned fully in either direction.

The wipers operate automatically several times while the washer fluid is being sprayed.

• The rear window wiper will automatically perform several continuous operations NOTE

• The rear window wiper will automatically perform several continuous operations if the gearshift lever or the selector lever is put in the “R” position while the windscreen wipers or the rear window wiper is operating. (automatic operation mode).

After the automatic operation, the rear window wiper will stop operating if the knob is in the “OFF” position. If the knob is in the “INT” position, the rear window wiper will return to the intermittent operation.

It is possible to set the rear window wiper to perform the automatic operation only if the gearshift lever or the selector lever is put in the “R” position while the rear window wiper is operating with the knob in the “INT” position.

For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

• If the knob is in the “OFF” position, turn the knob to the “INT” position twice quickly to operate the rear window wiper continuously.

(continuous operation mode) Turn the knob to the “OFF” position to stop the rear window wiper continuous operation.

• The interval for intermittent operation can be adjusted.

For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.

Refer to the separate owner’s manual for details.

READ NEXT:

 Headlamp washer switch

The headlamp washer can be operated with the ignition switch or the operation mode in ON or ACC and the lamp switch at the position. Push the button once and the washer fluid will be sprayed on t

 Rear window demister switch

The rear window demister switch can be operated when the engine is running. Push the switch to turn on the rear window demister. It will be turned off automatically in about 20 minutes. To turn off

 Horn switch

Press the steering wheel on or around the mark.

SEE MORE:

 Rear-view camera

The rear-view camera is a system that shows the view behind the vehicle on a screen of the MITSUBISHI Multi Communication System (MMCS) or the inside rear-view mirror. Caution ► The rear-view camera is an assistance system that enables the driver to check for obstacles behind the vehi

 To check the fluid level

The fluid level must be between the “MAX” and “MIN” marks on the reservoir. The fluid level is monitored by a float. When the brake fluid level falls below the “MIN” mark, the brake fluid warning lamp lights up. The fluid level falls slightly with wear of the brake pads, but this d

© 2010-2026 Copyright www.mioutlander.com