Mitsubishi Outlander: Reversing sensor system warning display
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Reversing sensor system / Reversing sensor system warning display
In case there is a malfunction in the reversing sensor system, the display for the malfunctioning sensor will blink and the warning buzzer will sound for approximately 5 seconds. Even after the buzzer has stopped sounding, the display will continue blinking until the system reverts to the normal state. Have the vehicle inspected at a MITSUBISHI MOTORS Authorized Service Point.
READ NEXT:
Rear-view camera
The rear-view camera is a system that shows the view behind the vehicle on a
screen of the MITSUBISHI Multi Communication System (MMCS) or the inside rear-view
mirror.
Caution
► The rear-
Range of view of rear-view camera
The range of view of the rear-view camera is limited to the area shown in the
illustrations. It cannot show both sides and the lower part of the rear bumper,
etc.
When reversing, be sure to visua
How to use the rear-view camera
When you place the gearshift lever or the selector lever in the “R” position
with the ignition switch in the “ON” position, the view behind the vehicle will
automatically appear on the scr
SEE MORE:
2010 Mitsubishi Outlander Review
While Mitsubishi's Outlander got a whole new front-end look for 2010, what it
really needed was a remake of its base four-cylinder engine, which is weak and
doesn't get good gas mileage, either.
Some problems with a car can be overlooked if there are enough positives to
overcome them. The Ou
To change the language of PTY display
You can select your favourite language between English, French, German, Swedish,
Spanish and Italian.
1. Turn off the radio. 2. Turn the radio back on while holding down the PTY
button (B). 3. An alarm will sound and the system will enter PTY Language Switching
mode. 4. Use the H button (C) o
© 2010-2026 Copyright www.mioutlander.com
