Mitsubishi Outlander: Roof carrier mounting brackets
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Cargo loads / Roof carrier mounting brackets
When installing the roof carrier, use the brackets (A).
The brackets (A) are located under each cover (B).
Attaching the roof carrier
Slide each cover (B) towards the front of the vehicle to remove it.
Refitting the covers
1. With each cover, put the tabs (C) on the cover in the holes (D) in the roof.
2. Slide the cover (B) towards the rear of the vehicle to install it.
READ NEXT:
Roof carrier precaution
Caution
► Make sure that the weight of the luggage does not exceed the allowable roof
load.
If the allowable roof load is exceeded, this may cause damage to the vehicle.
The roof load is t
Trailer towing
In order to tow a trailer with your vehicle, when having a trailer towing device
mounted that meets all relevant regulations in your area, consult a MITSUBISHI MOTORS
Authorized Service Point.
Th
Maximum towable weight with brake and maximum trailer-nose weight
Never exceed the maximum towable weight with brake and the maximum trailer-nose
weight as listed in the specifications. (Refer to “Vehicle weight”.)
If you tow a trailer at an altitude of more
SEE MORE:
Cargo loads precautions
Caution
► Do not load cargo or luggage higher than the top of the seatback. Be sure
that your cargo or luggage cannot move once your vehicle is moving.
Having the driver’s vision blocked, and your cargo being thrown inside the cabin
if you suddenly have to brake can cause a serious ac
Electric power steering system (EPS)
The electric power steering system (EPS) uses an electric motor to assist the
turning of the steering wheel.
NOTE
• During repeated full-lock turning of the steering wheel (for example, while
you are manoeuvring the vehicle into a parking space), a protection function may
be activated to
© 2010-2026 Copyright www.mioutlander.com
