Mitsubishi Outlander: To change the indication on the screen of the inside rear-view mirror
It is possible to turn off the screen of the inside rearview mirror and change the language of the warning messages on the screen.
To temporarily set the non- display mode
If you press the switch (1) while the image appears on the display, it goes off temporarily.
To return to display mode, press the switch again or turn the ignition switch to the “ON” position after turning to “LOCK” or “ACC” position.
To permanently set the non- display mode
1. Turn the ignition switch to the “ON” position.
Caution
► For safety reasons, do not perform following operations with the engine running.
2. Put the gearshift lever or the selector lever in the “R” position.
3. Press and hold down the switch (1) (for about 15 seconds).
While you keep the switch pressed, the orange indicator (2) comes on. When the image goes off, the non-display mode setting is completed.
To change the language of warning text(3)
1. Turn the ignition switch to the “ON” position.
Caution
► For safety reasons, do not perform following operations with the engine running.
2. Put the gearshift lever or the selector lever in the “R” position.
3. Press and hold down the switch (1) to enter language selection mode (for 6 to
11 seconds).
In this mode, the image appears and the green indicator (2) comes on.
4. Press the switch until the desired language appears on the display.
Each time you press the switch, the language will change to the next one. When the
warning text flashes, setting is completed.
READ NEXT:
Cargo loads precautions
Caution
► Do not load cargo or luggage higher than the top of the seatback. Be sure
that your cargo or luggage cannot move once your vehicle is moving.
Having the driver’s vision blocked,
Loading a roof carrier
Caution
► Use a roof carrier that properly fits your vehicle.
Do not load luggage directly onto the roof.
For installation, refer to the instruction manual accompanying the roof carrier.
N
SEE MORE:
Changing the momentary fuel consumption display (Type 2)
It is possible to change the bar graph setting of the momentary fuel consumption
display.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition sw
Interior (LHD, RHD)
1. Luggage compartment levers
2. Coat hook
3. Assist grips
4. Supplemental restraint system - curtain airbag
5. Rear room lamp
6. Rear seat
7. Cup holder (for rear seat)
8. Armrest
9. Adjustable load floor
10. Cargo floor boxes
11. Tether anchorages for child restraint system
