Mitsubishi Outlander: To temporarily increase or decrease the speed
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Cruise control / To temporarily increase or decrease the speed
To temporarily increase the speed
Depress the accelerator pedal as you would normally.
When you release the pedal, you will return to your set speed.
Note
► In some driving conditions, the set speed driving may be deactivated. If this happens, refer to “To activate” and repeat the speed setting procedure.
To temporarily decrease the speed
Depress the brake pedal to decrease the speed. To return to the previously set speed, press the “ACC RES” switch (C). Refer to “To resume the set speed”.
READ NEXT:
To deactivate
The set speed driving can be deactivated as follows: ► Press the “ON OFF” switch
(A). (Cruise control will be turned off.)
► Press the “CANCEL” switch (D).
► Depress the
To resume the set speed
If the set speed driving is deactivated by the condition described in “To deactivate”, you can resume the previously set speed by pressing the “ACC RES”
switch (C) while driving at a speed o
Reversing sensor system
This system operates when you are backing the vehicle.
It uses corner and back sensors to detect an obstacle and the information screen
in the multi-information display and the buzzer to inform you
SEE MORE:
Steering control switch
1- Volume up button
2- Volume down button
3- SPEECH button
4- PICK-UP button
5- HANG-UP button
Volume up button
Press this button to increase the volume.
Volume down button
Press this button to decrease the volume.
SPEECH button
► Press this button to change to voice recognition
Petrol-powered vehicles
1600 models
AS&G: Auto Stop & Go (AS&G) system
Note
► The values shown above apply to a vehicle on which optional equipment has not
been fitted.
► The results given do not express or imply any guarantee of the fuel consumption
of the particular vehicle.
The vehicl
© 2010-2025 Copyright www.mioutlander.com
