Mitsubishi Outlander: To use the external audio input function
Auxiliary Audio connector (RCA)
A- Left audio input connector (white)
B- Right audio input connector (red)
You can listen to commercially available audio equipment, such as a portable audio system, from your vehicle’s speakers, by connecting the audio equipment to the audio input connectors, which are external input connectors (pin jacks).
To activate the external audio input mode
A- CD button
B- AM/FM button
1. Use a commercially available audio cable to connect the audio equipment to
the internal audio input connector.
2. Press the CD button for more than 2 seconds.
The display will show “AUX” and then the external audio input mode will be activated.
3. To deactivate the external audio input mode, press the AM/FM button or the CD button to switch to another mode.
CAUTION
• Do not operate the connected audio equipment while driving.
This could distract you and an accident might occur.
NOTE
• The connected audio equipment cannot be operated with the vehicle’s audio system.
• For information on how to connect and operate the audio equipment, refer to the owner’s manual for the equipment.
READ NEXT:
Steering wheel audio remote control switches
The remote control switch is located on the left side of the steering wheel.
It can be used when the ignition switch or the operation mode is in ON or ACC.
1- Volume up button
2- Volume down butt
Error codes
If an error code appears in the display, take action in accordance with the table
below.
Error codes (iPod)
If an error code appears in the display, take action in accordance with the table
below.
SEE MORE:
Automatic transmission fluid
The proper amount of automatic transmission fluid is essential to the life and
operation of the automatic transmission. Either insufficient fluid or excessive
fluid could cause transmission trouble. The transmission fluid filler port cap is
equipped with a dipstick. Use the following procedu
Average speed
For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This
value shows the average speed (in km/h or mph) since the display was reset. If you
reset the display at the time when you want to start the measurements, average speed
from that point of time can be displayed.
