Mitsubishi Outlander: Tools and jack
The storage location of the tools and jack should be remembered in case of an emergency.
Location
1- Tools
2- Jack
Tools
1- Tool bag
2- Wheel nut wrench
3- Bar
Jack
1- To remove
Turn the shaft end so that the jack retracts and detach it from fixing bracket (A).
2- To store
Turn the shaft end by hand to expand the jack until it is secured firmly in position.
READ NEXT:
Jacking up the vehicle
1. Park the vehicle on a level and stable ground. 2. Activate the hazard flashers
and turn the ignition key to the “LOCK” position. 3. Set the parking brake firmly,
move the gearshift lever (m
Spare wheel
Check the air pressure in the spare tyre weekly, making sure it is ready for
emergency use. Maintaining the spare wheel at the highest specified air pressure
will ensure that it can always be us
Wheel covers
To remove
Wrap the tip of the wheel nut wrench with a cloth, insert it at the edge of the
wheel cover, and pry the cover away from the wheel.
NOTE
The wheel cover is made of plastic; take care
SEE MORE:
To enter frequencies into the memory
Manual setting
You can assign to the memory select buttons (3) a maximum of 18 stations in the
FM band (6 FM1, 6 FM2 and 6 FM3 stations) and 6 stations each in the MW and LW band.
(Stations already assigned to the memory select buttons are replaced by any newly
assigned stations.)
Follow t
Auto Stop & Go (AS&G) system
The Auto Stop & Go (AS&G) system automatically stops and restarts the engine
without operating the ignition switch or the engine switch when the vehicle is stopped,
such as at a traffic light or in a traffic jam, to reduce exhaust gases and increase
fuel efficiency.
CAUTION
• If t
© 2010-2025 Copyright www.mioutlander.com
