Mitsubishi Outlander manuals

Mitsubishi Outlander: Towing the vehicle by a tow truck

CAUTION

(1) This vehicle cannot be towed by a tow truck using Type A equipment to prevent the bumper from deformation. If this vehicle is towed, use Type B, Type C, Type D or Type E equipment.
(2) In case the vehicle with automatic transmission must be towed farther than 30 km, transport the vehicle with all wheels off the ground (Type B or C) or with front wheels off the ground (Type D).
(3) If the transmission is not operating, transport the vehicle with all wheels off the ground (Type B or C).

Towing with front wheels off the ground (Type D)

Release the parking brake. Place the gearshift lever (manual transmission) or the selector lever (automatic transmission) in the “N” (NEUTRAL) position.

Towing with rear wheels off the ground (Type E)

Place the gearshift lever (manual transmission) or the selector lever (automatic transmission) in the “N” (NEUTRAL) position.

Turn the ignition key to the “ACC” position and secure the steering wheel in a straightahead position with a rope, etc.

Never place the ignition key in the “LOCK” position. It is dangerous as the steering wheel may lock.

READ NEXT:

 Engine overheating

If the water temperature gauge indication remains in the overheating zone for a long time, the engine may be overheating. If this occurs, take the following corrective measures : 1. Stop the vehi

 Emergency starting

If the engine cannot be started because the battery is weak or dead, the battery from another vehicle can be used with jumper cables to start the engine. WARNING To start the engine by use of jump

 Bleeding the fuel system (diesel-powered vehicles only)

The fuel system should be bled to remove air as described below if the fuel supply is exhausted during travel. 1. Undo the four clips on the air cleaner and push the cover (B) aside. 2. Press

SEE MORE:

 3–point type seat belt (with emergency locking mechanism)

This type of belt requires no length adjustment. Once worn, the belt adjusts itself to the movement of the wearer, but in the event of a sudden or strong shock, the belt automatically locks to restrain the wearer’s body. To fasten Pull the seat belt out slowly while holding the latch plate

 Instruments and controls

LHD 1. Combination headlamps and dipper switch Turn-signal lever Front fog lamp switch* Rear fog lamp switch Headlamp washer switch* 2. Instruments 3. Shift paddles* 4. Windscreen wiper and washer switch Rear window wiper and washer switch 5. Engine switch* 6. Cruise contr

© 2010-2026 Copyright www.mioutlander.com