Mitsubishi Outlander manuals

Mitsubishi Outlander: What to do if the engine speed becomes unstable after the battery is replaced

Mitsubishi Carisma / Mitsubishi Carisma Owner's Manual / For emergencies / What to do if the engine speed becomes unstable after the battery is replaced

If the engine speed becomes unstable after the battery is replaced, reset the engine using the following method:

1. Stop the vehicle in a safe place.
2. Place the gearshift lever (manual transmission) in the ”N” (Neutral) or the selector lever (automatic transmission) in the ”P” (PARK) position. Stop the engine.
3. Restart the engine.
4. Turn off the air conditioning (if so equipped).
5. Allow the engine to warm up until the needle in the water temperature gauge stabilizes near the centre of the gauge.
6. Stop and restart the engine.
7. Allow the engine to idle for approximately 10 minutes.
8. When the engine speed stabilizes, the resetting procedure is complete.

NOTE

If the engine speed remains unstable after the resetting procedure has been performed, have the vehicle inspected by an authorized MITSUBISHI dealer.

READ NEXT:

 Fuses

 Fuse block

To prevent damage to the electric system due to short-circuiting or overloading, each individual circuit is provided with a fuse. There are fuse boxes in the passenger compartment and in the eng

 Fuse load capacity

The fuse capacity and the name of the electrical systems protected by the fuses are indicated on the inside of the coin box located at the driver’s leg area and on the fuse box lid for fuses l

SEE MORE:

 To lock or unlock with the key

1- Lock 2- Unlock Note ► On vehicles equipped with the central door lock switch, when locking or unlocking with the key, only the driver’s door will be locked or unlocked. To lock or unlock all doors and the rear hatch, use the central door lock switch, the keyless entry system or

 Parking

Parking on a slope Fully engage the parking brake, and then move the gearshift lever to 1st (on an uphill) or reverse (on a downhill) position on manual transmission vehicle. On automatic transmission vehicle, move the selector lever to “P” position. When parking on a hill, apply chocks t

© 2010-2025 Copyright www.mioutlander.com