Mitsubishi Outlander: Wheel covers
To removeWrap the tip of the jack bar with a cloth, insert it deeply into the notch provided in the wheel cover, and pry the cover away from the wheel. Using the same procedure at the other wheel cover notches, work the wheel cover away from the wheel to remove it completely.
CAUTION
• Removing the cover with your hands may cause injury to the fingers.
NOTE
• The wheel cover is made of plastic. Pry it loose carefully.
To install
1. Make sure the tabs (A) of the back of the wheel cover are not broken and correctly fitted on the rings (B). If in doubt, do not install the wheel cover and consult a MITSUBISHI MOTORS Authorized Service Point.
2. Align the tyre valve stem (C) with the cut out area (D) in the wheel cover.
NOTE
There is a symbol (E) on the back of the wheel cover indicating the cut out area.
3. Push the underside (F) of the wheel cover into the wheel.
4. Gently push both sides (G) of the wheel cover and hold them in place with
both knees.
5. Gently push around the top (H) of the wheel cover.
READ NEXT:
If your vehicle needs to be towed
If you need to tow your vehicle, we recommend that you contact a MITSUBISHI MOTORS
Authorized Service Point or tow truck company.
In the following cases, transport the vehicle using a tow truck.
Towing the vehicle by a tow truck
• This vehicle must not be towed by a tow truck using sling lift type equipment
(Type A) as illustrated. Using a sling lift will damage the bumper and front end.
• Do not tow 2WD vehicles with
SEE MORE:
Ignition switch turn-off reminder system
When the ignition switch is in any position other than the “LOCK” (PUSH OFF)
position, if you close all the doors and the rear hatch then try to lock the doors
and rear hatch by pressing the driver’s or front passenger’s door lock/unlock switch,
or the rear hatch LOCK switch, a warni
Changing the turn-signal sound
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the
