Mitsubishi Outlander: Changing the turn-signal sound
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Changing the function settings (when the ignition switch is “ON”) / Changing the turn-signal sound
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select
(changing the turn-signal sound).
3. Press and hold the multi-information meter switch for about 2 seconds or more to switch in sequence from 1 (turn-signal sound 1) → 2 (turn-signal sound 2) → 1 (turn-signal sound 1).
The setting changes to the selected turn-signal sound.
READ NEXT:
Changing the momentary fuel consumption display (Type 2)
It is possible to change the bar graph setting of the momentary fuel consumption
display.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setti
Returning to the factory settings
All of the function settings can be returned to their factory settings.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to th
SEE MORE:
Warning lamp
The ABS warning lamp should illuminate when the ignition switch is turned ”ON”,
and should go off in a few seconds.
CAUTION
If the warning lamp stays on or does not illuminate when you start the
vehicle, it indicates that the ABS is not functioning and that only the standard
brake syst
Washer fluid
Open the washer fluid reservoir cap and check the level of washer fluid with
the dipstick.
If the level is low, replenish the container with washer fluid.
NOTE:
● The washer fluid container serves the windscreen, rear window and headlamps.
During cold weather
To ensure proper operatio
© 2010-2026 Copyright www.mioutlander.com
