Mitsubishi Outlander: 3-point type seat belt with 2 buckles
3-point type seat belt with 2 buckles is fitted in the rear centre seating position.
To fasten
1. Pull the seat belt out slowly and pass it through the seat belt guide (A).
NOTE
• When the seat belts cannot be pulled out in a locked condition, pull the belt once forcefully and then return it.
After that, pull the belt out slowly once again.
2. After making sure that the seat belt is not twisted, insert the latch plate (B) into the buckle (C) aligning the marks (D) on the plate and buckle until a “click” is heard.
WARNING
• When using the seat belt, make sure to securely connect the latch plate (B) with the buckle (C). Failing to do so could significantly reduce the amount of protection and cause serious injures in a collision or a sudden stop.
3. Insert the latch plate (E) into the buckle (F) until a “click” is heard.
4. Make sure the lap belt is positioned as low as possible on the hips and pull the shoulder belt to adjust the slackness of the lap belt.
To unfasten
1. Hold the latch plate (E) and push the button on the buckle (F).
2. Push the button (G) on the buckle (C) using the latch plate (E) to disconnect the seat belt from the buckle.
3. Retract the seat belt and remove it from the seat belt guide (A).
4. After the seat belt is retracted completely, insert the latch plate (E) into the upper slit (H) and the latch plate (B) into the lower slit (I).
READ NEXT:
Pregnant women restraint
WARNING
• Seat belts work for everyone, including pregnant women. Pregnant women should
use the available seat belts. This will reduce the likelihood of injury to both
the woman and the unborn
Seat belt pretensioner system and force limiter system
The driver’s seat and front passenger’s seat each have a seat belt equipped with
a pretensioner system.
Pretensioner system
When the ignition switch or the operation mode is under the followin
Child restraint
When transporting children in your vehicle, some type of child restraint system
should always be used according to the size of the child. This is required by law
in most countries.
The regulation
SEE MORE:
Caution for installing the child restraint on vehicles with a front
passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
WARNING
• Extreme Hazard! Do not use a rearward facing child restraint on a seat protected
by an airbag in front of it!
NOTE
• The labels may be in different positions depending on the vehicle model.
Electronic immobilizer (Antitheft starting system)
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Electronic immobilizer (Anti-theft starting
system)”.
[Except for vehicles equipped with keyless operation system
