Mitsubishi Outlander: Child restraint
When transporting children in your vehicle, some type of child restraint system should always be used according to the size of the child. This is required by law in most countries.
The regulations concerning driving with children in the front seat may differ from country to country.
You are advised to comply with the relevant regulations.
WARNING
• When possible, put children in the rear seat. Accident statistics indicate that children of all sizes and ages are safer when properly restrained in the rear seat rather than in the front seat.
• Holding a child in your arms is no substitute for a restraint system. Failure to use a proper restraint system can result in severe or fatal injury to the child.
• Each child restraint device or fixing is to be used only by one child.
• When attaching a child restraint to the rear seat, place the front seatbacks in the upright position.
Otherwise, the child could be seriously injured in the event of hard braking or a collision.
- Caution for installing the child restraint on vehicles with a front passenger airbag
- Infants and small children
- Older children
- Suitability for various ISOFIX positions
- Installing a child restraint system to the lower anchorage (ISOFIX child restraint mountings) and tether anchorage
- Installing a child restraint system to a3-point type seat belt (with emergency locking mechanism)
READ NEXT:
Caution for installing the child restraint on vehicles with a front
passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
WARNING
• Extreme Hazard! Do not use a rearward facing child restraint on a seat protected
by an airbag in front of
Infants and small children
When transporting infants and small children in your vehicle, follow the instruction
given below.
Instruction:
• For small infants, an infant carrier should be used. For small children whose
Older children
Children who have outgrown the child restraint system should be seated in the
rear seat and wear combination lap shoulder belt.
The lap portion of the belt should be snug and positioned low on the
SEE MORE:
Moving the gearshift lever to the “R” (Reverse) position
Vehicles equipped with 5M/T
To shift into the “R” (Reverse) position from 5th gear, move the gearshift lever
to the “N” (Neutral) position, and then move it to the “R” (Reverse) position.
Vehicles equipped with 6M/T
Pull up the pull-ring (A), then move the gearshift lever to the “
Windscreen washer
The windscreen washer can be operated with the ignition switch in the “ON” or
“ACC” position.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards
you.
When the wipers are not in operation or in intermittent operation, by pulling
the lever towards you, th
