Mitsubishi Outlander: Suitability for various ISOFIX positions
Key of characters to be inserted in the table above:
• IUF- Suitable for ISOFIX forward child restraints systems of universal category
approved for use in the mass group.
• IL- Suitable for particular ISOFIX child restraint systems given in the following
list (MITSUBISHI genuine parts).
• X- ISOFIX position not suitable for ISOFIX child restraint systems in this
mass group.
IL (Genuine part information)
CAUTION
• When installing a child restraint system, prevent the head restraint from touching the child restraint system by removing it or adjusting its height.
NOTE
• MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.
Suitability for various seating positions
With front passenger’s airbag deactivated by means of front passenger’s airbag ON-OFF switch
Key of characters to be inserted in the table above:
• U- Suitable for “universal” category restraints approved for use in this mass
group.
• L- Suitable for particular child restraints in the following list (MITSUBISHI
MOTORS genuine parts).
• X- Seat position not suitable for children in this mass group.
L (Genuine part information)
CAUTION
• When installing a child restraint system, prevent the head restraint from touching the child restraint system by removing it or adjusting its height.
NOTE
• There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0-Up to 10 kg”.
MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.
READ NEXT:
Installing a child restraint system to the lower anchorage (ISOFIX child
restraint mountings)
and tether anchorage
Lower anchorage location
Your vehicle’s rear seat is fitted with lower anchorages for attaching a child
restraint system with ISOFIX mountings.
Tether anchorage locations
There are 2 child re
Installing a child restraint system to a3-point type seat belt (with
emergency locking
mechanism)
3-point type seat belt location
The child restraint system can be fitted by using the 3-point type seat belt
at the below illustrated seating position.
Installation:
1. Fasten the seat belt to
Seat belt inspection
• Check the belts for cuts, worn or frayed webbing and for cracked or deformed
metallic parts. Replace the belt assembly if it is defective.
• A dirty belt should be cleaned with neutral deterg
SEE MORE:
Cooling (Vehicles with air conditioning)
Set the mode selection dial to the “”
position.
Set the air selection switch (A) to the outside position and push the air conditioning
switch (B).
Adjust the temperature by turning the temperature control dial clockwise or anticlockwise.
Select the desired blower speed.
NOTE
If the o
Brake pedal free play
Stop the engine, depress the brake pedal several times, and press down the pedal
with your fingers until initial resistance is felt. This distance should be within
the specified range.
A- Free play: 3 to 8 mm
If the brake pedal free play is not within the standard range, have the brake
ped
