Mitsubishi Outlander: Cooling (Vehicles with air conditioning)
Set the mode selection dial to the “
”
position.
Set the air selection switch (A) to the outside position and push the air conditioning switch (B).
Adjust the temperature by turning the temperature control dial clockwise or anticlockwise. Select the desired blower speed.
NOTE
If the outside air is dusty or otherwise contaminated, or if high cooling
performance is desired, set air selection switch to the recirculation position and
the temperature control dial all the way to the left.
Switch to the outside position
periodically to increase ventilation so that the windows do not become fogged up.
CAUTION
When using the air conditioning, the idling speed may slightly increase as the air conditioning compressor is switched on/off automatically. Especially for vehicles with an automatic transmission, while the vehicle is stationary, fully depress the brake pedal to prevent the vehicle from creeping.
READ NEXT:
Automatic air conditioning*
The air conditioning can only be operated while the engine is running.
CAUTION
When using the air conditioning, the idling speed may slightly increase
as the air conditioning compressor is switche
Operating the system as an automatic air conditioning
In normal conditions, use the system in the AUTO mode and follow these procedures:
1- Set the blower speed selection dial to “AUT” position.
2- Turn the temperature control dial to set the des
Operating the system as a manual air conditioning
If you operate the blower speed selection dial or the mode selection dial as
you desired, the system is still automatically controlled except selected function
which dial is operated. To return al
SEE MORE:
Electric power steering system (EPS)
The electric power steering system (EPS) uses an electric motor to assist the
turning of the steering wheel.
NOTE
• During repeated full-lock turning of the steering wheel (for example, while
you are manoeuvring the vehicle into a parking space), a protection function may
be activated to
Rheostat (meter illumination control)
The rheostat can be adjusted while the lamp switch is “”
or “”. Turn the dial to adjust the meter
illumination to the desired brightness.
1- To increase brightness 2- To reduce brightness
