Mitsubishi Outlander: Operating the system as an automatic air conditioning
In normal conditions, use the system in the AUTO mode and follow these procedures:
1- Set the blower speed selection dial to “AUT” position.
2- Turn the temperature control dial to set the desired temperature.
The temperature can be set within a range of 15 to 29.
The temperature will gradually increase as the dial is turned to the right.
NOTE
Set the temperature, under normal operating conditions, at around 22.
3- Set the mode selection dial to “AUT” position.
4- Push the air conditioning switch to operate the air conditioning. When the
air conditioning operates, the operation indicator lamp (
)
in the dial will come on.
The outlet port (except “
” and “
”),
recirculation/outside – air select and blower speed, and ON/OFF of air conditioning
will be controlled automatically.
The following items are displayed in the multi center display. (Refer to “Multi center display” on page 4–24.)
A- Outside air temperature display/Set temperature display
B- Blower speed
indicator
C- Air flow indicator
NOTE
(1) The outside air temperature is usually displayed in the position (A). The set temperature is displayed for several seconds while the temperature control dial is operated.
(2) If the outside temperature drops below about 3 C, the alarm sounds and the outside temperature figure flashes for about 5 seconds. Turning the temperature adjustment dial during the period of the alarm will have no effect on the display. After completion of the warning, set the temperature. (Refer to “Outside temperature” on page 4–25.)
READ NEXT:
Operating the system as a manual air conditioning
If you operate the blower speed selection dial or the mode selection dial as
you desired, the system is still automatically controlled except selected function
which dial is operated. To return al
Change of mode selection
The mode selection dial is operated according to the need.
Turn the dial and the air outlet will be changed.
Air flow indicator (A) is displayed in the multi centre display.
A: From front a
Change of air selection
Every time the air selection switch is pressed, alteration is made between outside
air introduction and inside air recirculation. When inside air is recirculated,
the indicator lamp (A) comes on
SEE MORE:
To listen to tracks from a device connected via Bluetooth
1. Press the PWR button (2) to turn on the audio system. The system turns on
in the last mode used.
2. Press the CD button (1) several times to switch to the B (Bluetooth®) mode.
The input mode changes as follows every time the CD button is pressed.
CD mode → USB (iPod) mode → Blu
Wheel condition
1- Location of tread wear indicator 2- Tread wear indicator
Check the tyres for cuts, cracks and other damage. Replace the tyres if there
are deep cuts or cracks. Also check each tyre for pieces of metal or pebbles.
The use of worn tyres can be very dangerous because of the greater chance of
