Mitsubishi Outlander: Change of air selection
Every time the air selection switch is pressed, alteration is made between outside air introduction and inside air recirculation. When inside air is recirculated, the indicator lamp (A) comes on.
(Outside position)
Outside air is introduced into the passenger compartment.
(Recirculation position)
Air is recirculated inside the passenger compartment.
Normally, use outside position to keep the windscreen and side windows clear and quickly remove fog or frost from the windscreen.
If high cooling performance is desired, or if the outside air is dusty or otherwise contaminated, use the recirculation position. Switch to the outside position periodically to increase ventilation so that the windows do not become fogged up.
CAUTION
Use of the recirculation position for extended time may cause the windows to fog up.
READ NEXT:
Change of the blower speed
Adjust the blower speed by turning the blower speed selection dial clockwise
or anticlockwise.
The blower speed will gradually increase as the dial is turned to the right.
Blower speed indicat
Demisting of the windscreen and door windows
CAUTION
For safety, make sure you have a clear view through all windows.
To remove frost or mist from the windscreen and door windows, use the mode selection
dial (“” or “”).
- To keep
Cooling
Set the mode selection dial to the “”
position.
Set the air selection switch (A) to the outside position and push the air conditioning
switch (B).
Adjust the temperature by turning the tem
SEE MORE:
Engine oil
To check and refill engine oil
The engine oil used has a significant effect on the engine’s performance, service
life and startability. Be sure to use oil of the recommended quality and appropriate
viscosity.
All engines consume a certain amount of oil during normal operation. Therefore,
Gearshift lever position display
When the ignition switch is turned to the “ON” position, the position of the
gearshift lever is indicated in the multi-information display.
In addition, when the vehicle is driven with the gearshift lever in the “D” (DRIVE)
position, the forward gear number is shown.
If the gearshi
