Mitsubishi Outlander: Caution for installing the child restraint on vehicles with a front passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
WARNING
• Extreme Hazard! Do not use a rearward facing child restraint on a seat protected by an airbag in front of it!
NOTE
• The labels may be in different positions depending on the vehicle model.
Use rearward facing child restraints in the rear seat or turn off the front passenger’s airbag ON-OFF switch. (Refer to “To turn an airbag off”.)
WARNING
• A REARWARD FACING CHILD RESTRAINT must NOT be used in the front passenger seat if the front passenger’s airbag has not been deactivated.
The force of an inflating airbag could kill or cause serious injuries to the child. A rearward facing child restraint should be used in the rear seat.
• A FORWARD FACING CHILD RESTRAINT should be used in the rear seat whenever possible; if used in the front seat, turn off the front passenger’s airbag ON-OFF switch.
READ NEXT:
Infants and small children
When transporting infants and small children in your vehicle, follow the instruction
given below.
Instruction:
• For small infants, an infant carrier should be used. For small children whose
Older children
Children who have outgrown the child restraint system should be seated in the
rear seat and wear combination lap shoulder belt.
The lap portion of the belt should be snug and positioned low on the
Suitability for various ISOFIX positions
Key of characters to be inserted in the table above:
• IUF- Suitable for ISOFIX forward child restraints systems of universal category
approved for use in the mass group.
• IL- Suitable for
SEE MORE:
Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Except for vehicles equipped with the keyless operation system, remove the
key from the ignition switch. For vehicles equipped with the keyless operation system,
put the ope
Radio data system (RDS)
1- PWR (On-off) switch 2- TP (Traffic program) button 3- PTY (Program type)
button 4- U/M/L (UKW/MW/LW selection) button 5- TUNE/SEEK (Down-step/Downseek)
button 6- TUNE/SEEK (Up-step/Up-seek) button 7- Memory select buttons 8- Frequency
display window 9- RDS (Radio data system) indicator 10
