Mitsubishi Outlander: Seat belt pretensioner system and force limiter system
The driver’s seat and front passenger’s seat each have a seat belt equipped with a pretensioner system.
Pretensioner system
When the ignition switch or the operation mode is under the following conditions, if there is a frontal impact or a side impact (vehicles equipped with SRS side airbags and SRS curtain airbags) severe enough to injure the driver and/or front passenger, the pretensioner system will retract their respective seat belts instantaneously, thus maximizing the seat belt’s effectiveness.
[Except for vehicles equipped with keyless operation system]
The ignition switch is in the “ON” or “START” position.
[Vehicles equipped with keyless operation system]
The operation mode is in ON.
WARNING
• To obtain the best results from your pretensioner seat belt, make sure you have adjusted your seat correctly and wear your seat belt properly.
CAUTION
• Installation of audio equipment or repairs in the vicinity of the pretensioner seat belts or floor console must be performed in line with MITSUBISHI MOTORS guidelines. It is important to do so because the work could affect the pretensioner systems.
• If you need to scrap the vehicle, please consult a MITSUBISHI MOTORS Authorized Service Point.
It is important to do so because unexpected activation of the pretensioner seat belts could cause injuries.
NOTE
• The pretensioner seat belts will be activated if the vehicle suffers a severe frontal impact or a severe side impact (vehicles equipped with SRS side airbags and SRS curtain airbags), even if the seat belts are not worn.
• The pretensioner seat belts are designed to work only once. After the pretensioner seat belts have been activated, we recommend you have it replaced by a MITSUBISHI MOTORS Authorized Service Point.
SRS warning
The same warning lamp/display is shared by the SRS airbags and the pretensioner seat belts.
Refer to “SRS warning lamp/display”.
Force limiter system
In the event of a collision, each force limiter system will effectively absorb the load applied to the seat belt to minimize the impact to the passenger.
READ NEXT:
Child restraint
When transporting children in your vehicle, some type of child restraint system
should always be used according to the size of the child. This is required by law
in most countries.
The regulation
Caution for installing the child restraint on vehicles with a front
passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
WARNING
• Extreme Hazard! Do not use a rearward facing child restraint on a seat protected
by an airbag in front of
Infants and small children
When transporting infants and small children in your vehicle, follow the instruction
given below.
Instruction:
• For small infants, an infant carrier should be used. For small children whose
SEE MORE:
ACD (Active centre differential system
The ACD is a system that improves acceleration performance and straight-ahead
stability by regulating the differential limiting action and power drive distribution
of the centre differential.
Caution
► Do not over-rely on the ACD. Even the ACD cannot prevent the natural laws
of physic
Passenger compartment (LHD vehicles)
The fuse blocks in the passenger compartment are located behind the fuse lid
in front of the driver’s seat at the position shown in the illustration.
A- Main fuse block
B- Sub fuse block
1. Open the fuse lid and pull to remove it.
2. On vehicles with bottom cover, use the puller to loose
