Mitsubishi Outlander: Driver’s seat belt warning lamp and display
Warning lamp
A tone and warning lamp are used to remind the driver to fasten the seat belt.
If the ignition switch is turned to the “ON” position or the operation mode is put in ON while a seat belt is not fastened, the warning lamp illuminates and the tone sounds for about 6 seconds to remind the driver to fasten the seat belt.
If the vehicle is driven without fastening the seat belt, approximately 1 minute after the ignition switch is turned to the “ON” position, the warning lamp illuminates and flashes repeatedly, and the tone sounds continuously. In addition, the warning display will be displayed on the information screen in the multi-information display.
The warning lamp goes off and the tone stops after approximately 90 seconds.
Subsequently, if the seat belt is still not fastened, the warning lamp and tone will be activated to remind the driver to fasten the seat belt whenever the vehicle is stopped and started again. The warning will operate in the same way if the seat belt is removed while driving the vehicle. The warning will stop when the seat belt is fastened.
READ NEXT:
Front passenger seat belt warning lamp
The front passenger seat belt warning lamp is located on the instrument panel.
The lamp comes on when a person sits on the front passenger seat but does not
fasten the seat belt. It goes off when
Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted.
Raise or lower the seat belt anchor (A) while pressing the lock knob (B).
WARNING
• When adjusting the seat belt anchor, set it at a position that
3-point type seat belt with 2 buckles
3-point type seat belt with 2 buckles is fitted in the rear centre seating position.
To fasten
1. Pull the seat belt out slowly and pass it through the seat belt guide (A).
NOTE
• When the se
SEE MORE:
The side airbags and curtain airbags ARE NOT DESIGNED TO DEPLOY when…
The side airbags and curtain airbags are not designed to deploy in conditions
where they cannot usually provide protection to the occupant. Typical conditions
are shown in the illustration.
1- Head-on collisions
2- Rear end collisions
Because the side airbags and curtain airbags do not prot
Selection of engine oil (diesel-powered vehicles)
(1) Select engine oil of the proper SAE viscosity number according to the atmospheric
temperature. (2) Use engine oil conforming to the following classification:
Type 1:ACEA classification: “For service B2-96 or B3-96” Type 2:API classification:
“For service CF”
NOTE
Use of additive
