Mitsubishi Outlander: Adjustable seat belt anchor (front seats)
Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Seat and seat belts / Seat belts / Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted.
Raise or lower the seat belt anchor (A) while pressing the lock knob (B).
WARNING
• When adjusting the seat belt anchor, set it at a position that is sufficiently high so that the belt will make full contact with your shoulder but will not touch your neck.
READ NEXT:
3-point type seat belt with 2 buckles
3-point type seat belt with 2 buckles is fitted in the rear centre seating position.
To fasten
1. Pull the seat belt out slowly and pass it through the seat belt guide (A).
NOTE
• When the se
Pregnant women restraint
WARNING
• Seat belts work for everyone, including pregnant women. Pregnant women should
use the available seat belts. This will reduce the likelihood of injury to both
the woman and the unborn
Seat belt pretensioner system and force limiter system
The driver’s seat and front passenger’s seat each have a seat belt equipped with
a pretensioner system.
Pretensioner system
When the ignition switch or the operation mode is under the followin
SEE MORE:
To temporarily increase or decrease the speed
To temporarily increase the speed
Depress the accelerator pedal as you would normally.
When you release the pedal, you will return to your set speed.
Note
► In some driving conditions, the set speed driving may be deactivated. If this
happens, refer to “To activate” and repeat the
Rear window demister switch
The rear window demister switch can be operated when the engine is running.
Push the switch to turn on the rear window demister.
It will be turned off automatically in about 20 minutes. To turn off the demister
within about 20 minutes, push the switch again.
The indication lamp (A) will illumin
© 2010-2026 Copyright www.mioutlander.com
