Mitsubishi Outlander: Front passenger seat belt warning lamp
Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Seat and seat belts / Seat belts / Front passenger seat belt warning lamp
The front passenger seat belt warning lamp is located on the instrument panel.
The lamp comes on when a person sits on the front passenger seat but does not fasten the seat belt. It goes off when the seat belt is subsequently fastened.
WARNING
• Do not install any accessory or sticker that makes the lamp difficult to see.
READ NEXT:
Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted.
Raise or lower the seat belt anchor (A) while pressing the lock knob (B).
WARNING
• When adjusting the seat belt anchor, set it at a position that
3-point type seat belt with 2 buckles
3-point type seat belt with 2 buckles is fitted in the rear centre seating position.
To fasten
1. Pull the seat belt out slowly and pass it through the seat belt guide (A).
NOTE
• When the se
Pregnant women restraint
WARNING
• Seat belts work for everyone, including pregnant women. Pregnant women should
use the available seat belts. This will reduce the likelihood of injury to both
the woman and the unborn
SEE MORE:
System armed mode
(The buzzer stops and the security indicator continues to blink with indicator’s
reduced lit-up duration time.) Once the system preparation mode has ended, the system
armed mode starts.
If an unlawful opening of any of the doors, rear hatch or bonnet is detected
during the system armed mode
Economical driving
For economical driving, there are some technical requirements that have to be
met. The prerequisite for low fuel consumption is a properly adjusted engine. In
order to achieve longer life of the vehicle and the most economical operation, have
the vehicle serviced by an authorized MITSUBISHI de
© 2010-2026 Copyright www.mioutlander.com
