Mitsubishi Outlander: System armed mode
(The buzzer stops and the security indicator continues to blink with indicator’s
reduced lit-up duration time.) Once the system preparation mode has ended, the system
armed mode starts.
If an unlawful opening of any of the doors, rear hatch or bonnet is detected
during the system armed mode, the alarm will be activated to warn people around
the vehicle of an abnormal condition.
Also, if unlawful moving of the vehicle is attempted or a vehicle intrusion is
detected, the alarm will be activated.
READ NEXT:
The turn-signal lamps blink and the siren sounds for approximately 30 seconds.
Refer to “Alarm activation”.
Note
► The alarm will resume if unlawful actions are taken again, even if the
It is possible to cancel the system activation during the system preparation
mode or the system armed mode.
In addition, it is possible to cancel the alarm once it has been activated.
Refer to “
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Turn the ignition switch to the “LOCK” position.
If you started the engi
SEE MORE:
1. Before replacing the battery, remove static electricity from your body by
touching a metal grounded object.
2. With the MITSUBISHI mark facing you, insert the cloth-covered tip of a straight
blade (or minus) screwdriver into the notch in the case and use it to open the case.
Note
►
Auxiliary Audio connector (RCA)
A- Left audio input connector (white)
B- Right audio input connector (red)
You can listen to commercially available audio equipment, such as a portable
audio system, from your vehicle’s speakers, by connecting the audio equipment to
the audio input connec
© 2010-2026 Copyright www.mioutlander.com
