Mitsubishi Outlander: Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Turn the ignition switch to the “LOCK” position.
If you started the engine with the key, remove the key from the ignition switch.
2. Place the lamp switch in the “OFF” position, and leave the driver’s door open.
3. Pull the windscreen wiper and washer switch towards you and hold it there. (Since the ignition switch is in the “LOCK” position, washer fluid will not be sprayed.)
4. After approximately 10 seconds, the buzzer will make a sound. Keep the windscreen
wiper and washer switch pulled towards you. (If the windscreen wiper and washer
switch was released, the setting change mode would be cancelled. To start over,
perform the procedure again from step 3.)
5. When the buzzer stops, with the windscreen wiper and washer switch still pulled
towards you, press the UNLOCK switch (A) on the remote control switch to select
the security alarm settings mode.
The settings mode can be toggled by pressing the UNLOCK switch. The mode can be confirmed from the number of times the buzzer sounds.
6. Any of the following operations can be used to terminate the system settings change mode.
• Releasing the windscreen wiper and washer switch.
• Closing the driver’s door.
• Inserting the key into the ignition switch.
• Placing the lamp switch in any position other than “OFF”.
• Allowing 30 seconds to pass without making any changes to the settings.
• Push the ignition switch to the “LOCK” (PUSH ON) position (Vehicles with keyless
operation system).
Note
► If anything with regard to making changes to the security alarm system settings
is hard to understand, please consult your MITSUBISHI MOTORS Authorized Service
Point.
► Avoid leaving valuable items inside the vehicle even when the security alarm system
has been set to the “active” mode.
READ NEXT:
Setting the system
Follow the procedure below to set the system to the system armed mode.
1. Turn the ignition switch to the “LOCK” position.
If you started the engine with the key, remove the key from the ignitio
Cancelling the system
The following methods can be used to cancel the system when it is in the system
preparation mode or the system armed mode.
► Pressing the UNLOCK switch on the remote control switch.
►
Alarm activation
When the system is in the system armed mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the doors, rear hatch or bonnet is opened
using a method other than the
SEE MORE:
Front console box
To open, push the lid.
Upper box
Note
► The Auxiliary Audio connector (RCA) or the Auxiliary Video connector (RCA)
is located in the front console box (if so equipped). For details, refer to “To
use the external audio input function”.
Lower box
Note
► Do not use the f
Operating range for starting the engine
The operating range is the interior of the vehicle.
: Forward direction
: Operating range
Note
► Even if it is within the operating range, if the keyless operation key is in
a small item holder such as the glove box, on top of the instrument panel, door
pocket or in the luggage co
